[1]胡仕腾,陈建会,汤 琦,等.强威粉KTC对丁基橡胶/聚丙烯热塑性动态硫化胶性能的影响[J].合成橡胶工业,2023,5:394-397.
HU Shi-teng,CHEN Jian-hui,TANG Qi,et al.Effect of StronWi powder KTC on properties of thermoplastic dynamic vulcanizates[J].China synthetic rubber industy,2023,5:394-397.
点击复制
强威粉KTC对丁基橡胶/聚丙烯热塑性动态硫化胶性能的影响(PDF)
HU Shi-teng,CHEN Jian-hui,TANG Qi,et al.Effect of StronWi powder KTC on properties of thermoplastic dynamic vulcanizates[J].China synthetic rubber industy,2023,5:394-397.
《合成橡胶工业》[ISSN:1000-1255/CN:62-1036/TQ]
- 期数:
- 2023年5期
- 页码:
- 394-397
- 栏目:
- 出版日期:
- 2023-10-15
文章信息/Info
- Title:
- Effect of StronWi powder KTC on properties of thermoplastic dynamic vulcanizates
- 文章编号:
- 1000-1255（2023）05-0394-04
- Author(s):
- HU Shi-teng1; CHEN Jian-hui2; TANG Qi1; ZONG Cheng-zhong1
- 1. School of Polymer Science and Engineering, Qingdao University of Science and Technology, Qingdao 266042, China; 2. Zhejiang Shitai Industrial Co Ltd, Sanmen 317199, China
- Keywords:
- thermoplastic dynamic vulcanizate; StronWi powder; butyl rubber; polypropylene; reinforcement; mechanical property; aging resistance
- 分类号:
- TQ 333.6
- DOI:
- DOI:10.19908/j.cnki.ISSN1000-1255.2023.05.0394
- 文献标识码:
- A
- 摘要:
- 以纳米级层状硅酸盐强威粉KTC为增强填料、丁基橡胶（IIR）和聚丙烯（PP）为基体，采用动态硫化方法制备了IIR/PP热塑性动态硫化胶（TPV），研究了KTC用量对TPV的力学性能、热性能和结晶性能、耐老化性能及微观形貌的影响。结果表明，随着KTC用量的增加，IIR/PP TPV的拉伸强度先增大后减小，当KTC用量为30份（质量）时，拉伸强度达到最大值，老化后力学性能具有较高的保持率，老化前后拉伸强度变化趋势相同；KTC对PP相的结晶有促进作用，随着KTC用量的增加，IIR/PP TPV的玻璃化转变温度和结晶温度升高；当KTC用量不大于30份时，其均匀取向插入IIR/PP TPV中，而当KTC用量继续增加时，则出现明显的团聚现象。
- Abstract:
- Thermoplastic dynamic vulcanizates (TPV) was prepared by dynamic vulcanization with nano-layered silicate StronWi powder KTC as reinforcing filler, butyl rubber (IIR) and polypropylene (PP) as matrix. The effect of amount of StronWi powder KTC on mechanical, thermal and crystallization properties, aging resistance and microstructure of IIR/PP TPV were studied. The results showed that with the increase of amount of KTC, the tensile strength of the TPV increased first and then decreased. The maximum tensile strength was reached when the amount of KTC was 30 phr. The mechanical properties of TPV had a higher retention rate after aging, and the change trend of tensile strength after aging was the same as that before aging. KTC could promote the crystallization behavior of PP. With the increase of amount of KTC, the glass transition temperature and crystallization temperature of TPV increased. When the amount of KTC was not more than 30 phr, KTC inserted into TPV with uniform orientation. When the amount of KTC continued to increase, the aggregation was obvious.
参考文献/References
［1］ 林靖淞， 伍宏明， 彭晓涵， 等. 交联剂DCP对PP/EPDM动态硫化热塑性弹性体影响［J］. 工程塑料应用， 2020， 48（7）： 121-127.［2］ 何剑杰， 王建国， 孙东. PP/EPDM动态硫化热塑性弹性体的改性研究进展［J］. 工程塑料应用， 2019， 47（2）： 148-153.［3］ Hou Jiarui， Zhong Ming， Pan Xiaolong， et al. Fabricating 3 D printable BIIR/PP TPV via masterbatch and interfacial compa-tibilization［J］. Composites （Part B）：Engineering， 2020， 199： 108220.［4］ 钟明. 低硬度、可3 D打印BIIR/PP-TPV的制备及结构与性能研究［D］. 青岛： 青岛科技大学， 2019.［5］ Pavlidou S， Papaspyrides C D. A review on polymer-layered silicate nanocomposites［J］. Progress in Polymer Science， 2008， 33（12）： 1119-1198.［6］ 吴欣欣， 王世伟， 王仁平. 强威粉在天然橡胶汽车减震衬套胶料中的应用研究［J］. 橡胶科技， 2016， 14（3）： 29-32.［7］ 刘雅煊， 汤琦， 孙聚杰， 等. 有机蒙脱土/丁基橡胶/聚丙烯热塑性硫化胶的制备与性能［J］. 合成橡胶工业， 2021， 44（2）： 121-125.
备注/Memo
- 备注/Memo:
- 青岛市2021年博士后资助应用研究项目（040304031060092）
常用功能
统计/Statistics
- 摘要浏览/Viewed251
- 全文下载/Downloads469
- 评论/Comments
更新日期/Last Update:
1900-01-01